专题:Electronic Packaging and Soldering Technologies

This cluster of papers focuses on the advances and challenges in the use of lead-free solders, interfacial reactions between solders and base materials, reliability studies in electronic packaging, high-temperature electronics, nanoparticle applications, electromigration effects, thermal behavior, rare earth element additions, and the use of conductive adhesives as alternatives.
最新文献
Test design and results of a method performance characterization study for SPF and UVAPF testing

article Full Text OpenAlex

Characterization, Accelerated Life Testing, and Finite Element Modeling of Low Temperature Solder Wire Interconnect Degradation Mechanisms

article Full Text OpenAlex

Diffusion behavior and microstructural evolution of bonding interface between AuSn20 and tungsten-copper alloy

article Full Text OpenAlex

Effect of Bi additions on the microstructure evolution and surface instability during room-temperature aging of Sn alloys

article Full Text OpenAlex

Quantification of the Impact of Structure Quality on Predicted Binding Free Energy Accuracy

article Full Text OpenAlex

Nanoindentation Based Methodology to Characterize the Adhesion Strength of Dielectric Bond Interfaces

article Full Text OpenAlex

Fretting Wear and Corrosion in Liquid Lead-Bismuth Eutectic: A Review of Current State and Prospect

review Full Text OpenAlex

The impact of Ni and Zn doping on the stability, electrical and thermal conductivity of intermetallic compounds between Sn solder and Cu substrate

article Full Text OpenAlex

Current-Induced Evolving Mechanical Properties, Formation of Defects, and Interfacial Intermetallic Growth in the Interconnects Bonded with Au Wire

article Full Text OpenAlex

Ultrasonic-assisted soldering of 7075 Al alloy joint using Ni mesh reinforced SAC305 composite solder: microstructure, bonding ratio, and mechanical properties

article Full Text OpenAlex

近5年高被引文献
Recent Advances and Trends in Advanced Packaging

article Full Text OpenAlex 303 FWCI28.469

Advances on Thermally Conductive Epoxy‐Based Composites as Electronic Packaging Underfill Materials—A Review

review Full Text OpenAlex 262 FWCI5.733

Comparing the mechanical and thermal-electrical properties of sintered copper (Cu) and sintered silver (Ag) joints

article Full Text OpenAlex 177 FWCI11.936

Detection of solder paste defects with an optimization‐based deep learning model using image processing techniques

article Full Text OpenAlex 151 FWCI17.791

Effects of solder thickness on interface behavior and nanoindentation characteristics in Cu/Sn/Cu microbumps

article Full Text OpenAlex 119 FWCI11.368

In-situ isothermal aging TEM analysis of a micro Cu/ENIG/Sn solder joint for flexible interconnects

article Full Text OpenAlex 99 FWCI15.711

Semiconductor Advanced Packaging

book Full Text OpenAlex 97 FWCI14.482

Effects of Ni-decorated reduced graphene oxide nanosheets on the microstructural evolution and mechanical properties of Sn-3.0Ag-0.5Cu composite solders

article Full Text OpenAlex 97 FWCI9.267

Equilibrium phase diagram design and structural optimization of SAC/Sn-Pb composite structure solder joint for preferable stress distribution

article Full Text OpenAlex 96 FWCI15.22

An insight into dynamic properties of SAC305 lead-free solder under high strain rates and high temperatures

article Full Text OpenAlex 95 FWCI11.627